Nina Allen Freeman » Blog
Monoprint Demonstration
Posted on 6/13/2014 11:51:37 AM
By Nina Allen Freeman
Comment on this
Topics: painting demonstration

"Pink Lily" by Nina Allen Freeman
Monoprinting is done with media of all kinds but watercolor is the easiest and most forgiving to use. First, a Monoprint is a print that is taken only once. The resulting image can then be enhanced with paint, pencil or any other media. I introduced Monoprinting to my watercolor class as a fun project and found that with experimentation and work it is possible to create some wonderful pieces of art this way.
What materials are needed?
- 90# or 140# hot press watercolor paper or paper intended for printmaking-cut to desired size
- sheets of acrylic glazing used for framing-any size
- bottle of gum Arabic
- flat watercolor brush, watercolor brushes to paint with
- watercolor paints and supplies normally used
- sketch paper large enough to fit under your acrylic glazing
- brayer
- spray bottle of water
application of Gum Arabic
- brush onto the surface of the acrylic glazing (this is your "plate")a smooth coat of Gum Arabic (no water) and allow to dry.
- Sketch your subject on the sketch paper the same size as your plate.
- When the sketch is ready, place the plate on top of the sketch, Gum Arabic side UP.
painting on the plate
4. Following your sketch, paint with watercolor paint onto the plate. It works better to use a minimum of water and heavier application of pigment. Also, avoid over-working or lifting as this will lift the Gum Arabic layer. Gouache can also be used. When finished, allow to dry.
finished plate
5. Prepare your paper to receive the print by spraying the "to be PRINTED SIDE" of the paper thoroughly with water. Allow the water time to soak into the paper so that it is dull, not shiny and not dripping.
6. Center your paper, WET SIDE DOWN, over your dry, painted plate and lay it gently down.
7. Using the brayer, roll across the surface of the paper applying pressure evenly in all directions. Do this quickly then gently pull the print off the plate.
Print pulled from the plate
This last step is always a surprise. What printed and what didn't? What can I do to improve it without ruining its charm? The best part is that you have the sketch and simply need to rinse the plate, coat again with Gum Arabic and paint it differently the next time!
I welcome your comments on my Blog posts and look forward to them. If you have questions about painting methods or anything I have mentioned, I will respond to them via email as soon as I am able to. Keep painting! Nina Freeman
Leave a Comment